Think you're ready to cut? Why not be sure with our list of final checks to complete before you press go!
Before loading any material, check the machine:
Clean SmartBench
Empty vacuum bag
Clear SmartBench topside
Clear SmartBench underside
- Ensure power cords can move freely
- Ensure vacuum hose can move freely
Check that X and Y axes are sound (whilst powered on, there are no knocking noises when gently rocked)
Check the Z-head lead screw is lubed
Calibrate if high accuracy is required. Actions that can affect accuracy include:
- Moving the machine
- Ambient temperature changes
Load material
Secure spoil board/waste board (If applicable)
Secure stock material (clamps, glue, screws etc):
- Is your stock the correct thickness?
Clamp the beam, checking the beam wheels run on the surface
Home SmartBench
Select the correct router bit and check condition (is it sharp?)
Load tool into the spindle
Set your job XY datum (start point)
Set your Z-height
Close the dust shoe
In the manual move:
- Vac power check
- Spindle power check
SmartBench Safety
We take safety very seriously, so we've written an article here