Gain confidence in CNC machining with our CNC academy - all the knowledge and tools you will need to take that next step in expanding your business with SmartBench.
I'm running into a bit of trouble with the X axis.
During "homing" (and normal use) the carriage goes over the X axis without triggering the sensor. At least that is what I think is happening.
Sometimes it helps by cleaning the sensor and the magnet, but often it just runs over the sensor and keeps doing this.
Is there any way to avoid this?
This sounds like you may have an intermittent fault with the limit switch.
If you can please submit a support ticket, we can help diagnose and fix.